Your cart is empty.
Your cart is empty.The crankshaft position sensor communicates the position and speed of the crankshaft to the ECM to ensure proper timing of fuel injection and ignition. NTK's robust circuit board design increases durability and precision-wound, coated-copper windings increase longevity. The magnet size and strength in this sensor is optimized for precise signal output. NTK crank position sensors are 100% thermo-shock and vibration tested to ensure the best performance in extreme conditions.
Agent1123
Reviewed in the United States on January 6, 2025
The part was delivered as described.Installation was quick and easy enough for a DIYer with a little bit of patience to reach to points of connection.This part was used on a 1991 Jeep Cherokee Laredo
Brandon
Reviewed in the United States on April 1, 2025
1992 jeep Cherokee LaredoPart did not work, installed, uninstalled and repeated again. Had to put the old sensor back in and the XJ started again.
Roger
Reviewed in the United States on May 4, 2022
Installed the sensor, and vehicle (Jeep) would not start or even fire. It coughed a few times but that was it. I reinstalled the old one that I had suspected of going bad and Jeep started right up. I have bought a half dozen of these from various companies and they have all been bad in one way or another, except the one I bought at NAPA. This one was supposed to be American made (NGK/NTK) and on the outside of the box it is stamped made in the USA. Inside the box and printed on the box it says maybe not!
Recommended Products
$27.24
$ 13 .99 $13.99