Your cart is empty.
Your cart is empty.3.0 out of 5 stars
- #58,399 in Computers & Accessories (See Top 100 in Computers & Accessories)
- #1,171 in Laptop Screen Protectors
Product Description
How to Install?
Step 1: Compare screen sizes to make sure they are the same size. (Note: Face the side labeled "1" toward the laptop screen. Apply the positioning sticker to the same end as the "1" label)
Step 2: Use cleaning cloth to remove dust and stains.
Step 3: Use dust removal stickers to clean up fine dust to ensure that the screen is free of dust.(Note: Clean the screen, because dust can easily cause air bubbles!)
Step 4: Fixed "1"Tear off 4-6 cm from the bonding surface, align it with the edge of the screen and attach it.
Step 5: Tear off "1" the bonding surface on one side so that you can push it forward use a card.
Step 6: After pasting, Use card squeeze out the air bubbles, uncover "2" the outer mask, and finish.
Brant Hyland
Reviewed in the United States on December 17, 2024
Looking at screen protectors for my ASUS ProArt Studiobook 16 OLED W7604 laptop. This was the biggest screen protector listed for my laptop. All the others were just the size of the display and I wanted to protect the whole area. Purchased this one hoping that it would cover the whole area of the screen.When i received it, it only had one installation kit for two screen protectors. Test fit the screen protector on my laptop to notice that it is too high and the cutouts for the camera along with the sensors are wrong on top. Was going to return it but could not find another protector that was similar size for my laptop. Decided to trim the bottom edge and modify the camera cutouts on the top to get it to fit. Aligned the screen protector and secured it in place with tape per the instructions. When using the install kit, the wet cleaner left a residue on my screen that made it cloudy. Used a safety glass cleaner to clean it up. Even the dry cleaning wipe did not help. Installed the protector once the screen was clean. Used the tool to get all the air bubbles out but could not get the top edge to sit on the screen. Had to trim the top edge to get it to sit on the screen.This would have worked better if the cutouts were in the correct locations and the size was more accurate to this model of laptop.The screen protector is installed. The matt finish works out much better then the original glossy appearance. The touch screen works just fine and the color looks good.
Recommended Products