Your cart is empty.
Your cart is empty.Bruce
Reviewed in the United States on April 7, 2025
I used it to use my conical fermenter as a boil kettle for a distillation apparatus. This combined with a variac allowed me to control the rate of heating. The distillation proceeded smoothly. The amperage draw was as expected. It requires wiring and care should be taken to use an appropriate power cord.
rich slattery
Reviewed in the United States on May 29, 2024
For the price and durability it’s good
oornxlg
Reviewed in the United States on December 20, 2024
Quality item
Robert Frame
Reviewed in the United States on April 6, 2024
Worked great
pancho
Reviewed in Canada on August 3, 2023
needs better seals on the electrical end.
Tom
Reviewed in the United States on May 26, 2023
I am sorry that i have not got to this along time ago. For the rreason i bought this heater, it works perfectly
Russell Yarnell
Reviewed in the United States on December 23, 2023
Needed this for a project and the tri-clamp fitting is what drew my attention. Note that the cable gland is a PG-21. It is too big for any cable I am using on 120V. To achieve a sealed entrance, I used 3/4" x 1/2" reducer bushing and a 3/4" electrical locknut on the inside of the housing. I then bought some 1/2" NPT cable glands to thread into the reducer.
Jake
Reviewed in Canada on May 16, 2021
This is perfect well wrapped
Joe G
Reviewed in the United States on January 28, 2021
I used this to heat a 20 gallon tank to produce steam for a DIY pasterization tank. It worked fantastically and is holding up well. It takes about an hour to start creating steam but it makes enough steam to heat my pasterizer up to 200 F and keep it there. The element still looks fantastic after many cycles. I will buy this again.
Plasticized
Reviewed in the United States on March 11, 2020
Great element. Fits well, no leaks. I could use a larger wattage, but this product is very well made and worth the price. Mine did come with a screw on, metal cap. The hole in the cap is a little large for the gauge of wire i used (extension cord) so i wrapped with electric tape to snug the fit. Great for brewing or distilling with PID control. Boils my 5 gallon mashes in about an hour. I do recommend
brendan
Reviewed in Canada on August 1, 2019
I used this for a DIY all in one brewing setup. You need to make your own enclosure for the electronics. I would HIGHLY recommend connecting the ground line to your triclamp connector for some vague sense of safety as the element does not have a connection on it for that. personally i like this as safety is not my priority. beer is.This is a low watt density heater and I have not had any issues with burnt wort because of it.
Recommended Products