Shopping Cart

Your cart is empty.

Your cart is empty.

Comimark 1Pcs DRV8871 H-Bridge DC Motor Driver Breakout Board PWM Control Module 3.6A for Arduino

Free shipping on orders over $29.99

$9.99

$ 4 .99 $4.99

In Stock

About this item

  • Wide 6.5-V to 45-V Operating Voltage
  • PWM Control Interface
  • The DRV8871 device is a brushed-DC motor driver for printers, appliances, industrial equipment, and other small machines. Two logic inputs control the Hbridge driver, which consists of four N-channel MOSFETs that can control motors bidirectionally with up to 3.6-A peak current.
  • Package Included: 1pcs Board
  • If You Are Not Satisfied with Your Purchase for Any Reason, Please Feel Free To Contact Us at the Buyer Center or Support Email, 24/7 Quick Reply.


1 Features

1? H-Bridge Motor Driver

– Drives One DC Motor, One Winding of a

Stepper Motor, or Other Loads

? Wide 6.5-V to 45-V Operating Voltage

? 565-mΩ Typical RDS(on) (HS + LS)

? 3.6-A Peak Current Drive

? PWM Control Interface

? Current Regulation Without a Sense Resistor

? Low-Power Sleep Mode

? Small Package and Footprint

– 8-Pin HSOP With PowerPAD?

– 4.9 × 6 mm

? Integrated Protection Features

– VM Undervoltage Lockout (UVLO)

– Overcurrent Protection (OCP)

– Thermal Shutdown (TSD)

– Automatic Fault Recovery

2 Applications

? Printers

? Appliances

? Industrial Equipment

? Other Mechatronic Applications

3 Description

The DRV8871 device is a brushed-DC motor driver

for printers, appliances, industrial equipment, and

other small machines. Two logic inputs control the Hbridge

driver, which consists of four N-channel

MOSFETs that can control motors bidirectionally with

up to 3.6-A peak current. The inputs can be pulsewidth

modulated (PWM) to control motor speed, using

a choice of current-decay modes. Setting both inputs

low enters a low-power sleep mode.

The DRV8871 device has advanced currentregulation

circuitry that does not use an analog

voltage reference or external sense resistor. This

novel solution uses a standard low-cost, low-power

resistor to set the current threshold. The ability to limit

current to a known level can significantly reduce the

system power requirements and bulk capacitance

needed to maintain stable voltage, especially for

motor startup and stall conditions.

The device is fully protected from faults and short

circuits, including undervoltage (UVLO), overcurrent

(OCP), and overtemperature (TSD). When the fault

condition is removed, the device auto


Bob
Reviewed in the United States on May 6, 2022
Not a good product
A.A
Reviewed in the United States on December 27, 2022
bought 8, none worked, current stays at 0 no matter the input. 12V power, 5V logic, 6ohm load
DP
Reviewed in the United States on July 25, 2021
Easy to use and works just as described. I am so thankful when cheap stuff from amazon actually does what it is supposed to.