Your cart is empty.
Your cart is empty.
Brand Name: Amass
Product Type: XT30PW
Resistant current: 30A
Molded Case Material: Nylon
Surface treatment: frosted
Metal Material: Copper Gold Plated
Applicable products: suitable for small current small drone FPV motor ESC port
Parameter:
Body material and surface plating:brass and gold plated
Insulation material:PA66
Original internal resistance:0.8MΩ
Maximum continuous current within 30 minutes(temperature rise
Recommend cable specification:18AWG wire Φ2.8MM
Mechanical life:3000 times
Weight:1.7g/1.8g
Insulation material:UL94V-0
500 Times internal resistance:0.85MΩ
Maximum instantaneous current within 1 minute(temperature rise
Recommend soldering temperature and time:400℃/3S
Trough 20A current 10-300HZ Sweep vibration Amplitude 5MM Cycle 1MIN:Voltage stability No soaring or disappearing
Package included:
10 pairs Amass XT30PW connectors(10pcs female +10pcs male)
Dan B.
Reviewed in the United States on March 14, 2025
Solid connectors. I like the 90-degree bend in the solder side, as it makes connecting breadboards/edges much easier.Connector body is stout and heavy-duty, and will stand up to daily use and wear-and-tear.One thing to note - XT connectors sink quite a bit of heat when soldering, so you'll need to plan ahead how you want to assemble things, otherwise you might end up with some melty connectors and heat-shrink that's shrunk too early.
SKS
Reviewed in the United States on March 10, 2025
These connectors have good contacts and works well once connected. However I find fit little more sticky and difficult to take out. This is common problem with lot of cheaper ones. I have some other xt30 which are much smooth in putting or taking out.I will use it with the contacts that that will not have frequent removal.
Recommended Products
