Your cart is empty.
Your cart is empty.Product Description
MG996 Servo Motor
Notes:
- 1. For Engine Powered Airplane and Boats, Rubber Must Be Used to Reduce Vibration
- 2.Torque Over-Loaded Will Damage the Servo's Mechanism
- 3. Please Choose Correct Model for Your Application
- 4. Keep the Servo Clean and Away from Dust, Corrosive Gas and Humid Air
Accessories:
Steering Wheel, Fixing Screws,Rubber Sleeves and Aluminum Sleeves
Application:
Analog Servo Motor Great for RC Helicopters, Micro Robots,Robotic Arms and RC Rock Crawler, RC Boat Motor,Truck, Boat, Racing Car,Various Remote Control Toys
Specification:
- Gear Type: All Metal Gears
- Operation Voltage : 4.8 - 7.2Volts
- Operating Speed : 0.17sec / 60 degrees (4.8V no load)
- Operating Speed : 0.13sec / 60 degrees (6.0V no load)
- Stall Torque : 9.4 kg-cm (4.8V)
- Stall Torque : 11 kg-cm at (6V)
Wire:
- Signal Wire/PWM-----------------Yellow
- Positive Pole(+)---------------------Red
- Negative Pole/GND(-)------------Brown
- Connector Wire: Heavy Duty, 11.81" (300mm)
- Connector Wire Length: 300mm/11.8 in
- Connectors: Suitable for Most Futaba, Hitec, Sanwa, GWS Receiver Connector
Rec. It Studios
Reviewed in the United States on May 12, 2025
So far so good. Just installed in custom build. So will see.
Anne Rincon
Reviewed in the United States on March 3, 2025
Complete garbage quality. These gears strip so easily it leaves the servo useless. So fragile and weak. I buy MG996R servo in bulk regularly and these are the worst I have ever seen.
Recommended Products